Finished the Jack!!!
I finished my hydraulic jack!!! I'm going to send it to our school's holiday festival. My friend (the one right at the front) is...
I finished my hydraulic jack!!! I'm going to send it to our school's holiday festival. My friend (the one right at the front) is...
What I needed to do was to put knitting pins instead of toothpicks. The toothpicks just don't fit! But knitting pins are good because the...
I figured out that it probably isn't the holes in the , but because of the wire. There was a small space in between some of the wires, so...
I finished my jack! However, when I push the srynge in (you can see it in the picture) all it does is it makes it unstable. I don't know...
I have good news. I finished the main part of my hydraulic jack! And my friend gave me some srynges for it. I'll put it on tomorrow,...
Good news! I got the basic picture of what I'll do on the jack from the video. I followed its first steps. You could see that there are 2...
Okay, knitting was WAY too hard for me at this stage. I absolutely DO NOT get how to do the knit stitch (and that's one of the basic...
Good news and bad news. The good news is that I FINALLY managed to get the knit stitch. Or rather, the first part of it. That's the bad...
I learned how to do the single cast on, but for the actual stitch, I got COMPLETELY lost. I was trying to learn how to do the knit...
Today I made a pillow out of cloth sewed together with yarn for its stuffing. I was bored, and forgot about knitting until the end. The...
I pretty much was bored today. I decided to sew a pouch, except the sewing machines were full, and I couldn't get a needle out of the...
Today I went on YouTube and learned how to hand sew 3 stitches: The running stitch, back stitch and blanket stitch. I practiced all 3 of...
I sewed another 2 random pieces of cloth. I was sort of bored, so I just did that. But next, I want to learn how to hand sew, because it...
I learned how to use a sewing machine today. I started yesterday, but the sewing machine was broken because the part where the bobbin...
My new design was where the bottle was in the bowl. It worked, which is REALLY good! I'm not sure what I should do next. I think I'll...
Really really bad news! The wire fell off of the motor while I was trying to drill a hole! So it's in the bottle, and I can't get it out....
I have basically finished my final design. The only problem is that it's leaking from outside of the bottle, not inside. So basically,...
Great news! My prototype worked. It didn't leak, so now I will make a final design to take home later. I didn't get all the way through,...
I've revised my sketch to show the bowl part. I've done it, and I just need to test it. Hopefully, it'll work.
I am STILL testing! This is a LOT harder than I thought it would be! Whenever I plug up one hole, the other starts leaking. Next, I'm...