8/23/2018

Sarah Joo
Aug 23, 2018
1 min read

Today I started my project. I was going to melt plastic, so that I could make "walls" for my design. I used a heat gun, to melt the plastic, to make it flat. So, I turned it to the hottest setting, and melted it partially flat. Tomorrow, I plan to do the same thing, just work faster so that they will be ready when the materials bought online comes

Recent Posts

See All

Finished the Jack!!!

Setback 2

What I needed to do was to put knitting pins instead of toothpicks. The toothpicks just don't fit! But knitting pins are good because the...

Setbacks

I figured out that it probably isn't the holes in the , but because of the wire. There was a small space in between some of the wires, so...

Comentarios

bottom of page